81
Clear FAV SEL
Press SEL to clear the Favorites
Scan List.
Memory Info SEL
Press SEL to see the current mem-
ory usage. Use
5
and
6
keys to
scroll.
EXPERT BELOW
Tune LED On or Off
Activates Signal Strength driven
LED when in TUNE mode.
Color 0-7
R e d / G r e e n / B l u e
(RGB) value
Sets intensity of red, green and
blue LEDs. Press SEL to edit col-
ors. Use
34
keys to scroll to R,
G or B LED settings. Use numeric
keys to activate preset intensity lev-
els for each LED, or use
56
keys
to fine scroll intensity.
Qtxt1-0 Text value
Sets QTXT (QuickText) 0-9 text. Use
“$” to indicate end of text.
Key Repeat On or Off
Toggles key repeat mode when a
key is held down
LCD BlinkOff 1-250 x 10 mS
For alternating text displays, sets
the display time for the secondary
display element.
LCD BlinkOn 1-250 x 10 mS
For alternating text displays, sets
the display time for the primary dis-
play element.
LED BlinkOff 1-250 x 10 mS
When the ALERT LED setting for
an object is set to Flash, this is
the amount of time the LED stays
turned off.
LED BlinkOn 1-250 x 10 mS
When the ALERT LED setting for
an object is set to Flash, this is
the amount of time the LED stays
turned on.
Pri Channels 0-250
Number of priority CONV channels
to check during a priority scan sam-
pling. “0” samples all CONV priority
channels.
Pri Interval 2-100 x 100 mS
Conventional frequency priority
sample interval.
TGRP Pri Int On or Off
Toggles priority interrupt scanning
during trunked calls
QuickPriRtn On or Off
When on, does not wait for verifi-
cation of correct CTCSS, or DCS
when returning to an active CONV
channel after priority sampling
To Next Page
Loading...
