96
LED Mode Solid or Flash
Controls whether the ALERT LED
flashes or remains on solid when
the ALERT LED is used.
LED Color 0-7
Sets LED color to 0-7 as defined
in the GLOB menu. By default,
0=LED Off, 1=Red, 2=Yellow,
3 = G re e n , 4 = C y a n , 5 = B l u e ,
6=Magenta, 7=White.
Latch LED On or Off
Normally the ALERT LED is active
only while the object is receiving
a transmission. When Latch is
on, the ALERT LED will remain lit
after the transmission is complete,
unless overridden by a subsequent
object that is also using the ALERT
LED.
Backlight On, Off or Flash
Controls whether the backlight
should be on, off or flashing while
the object is active.
Alarm
None, Chirp, Hi-Lo,
Alert, Ring, 2-Chirp,
Fast Hi-Lo, DTMF#
Sets the Audible Alarm for the
SWPR object. When an Audible
Alarm is selected, the selected
alarm will play anytime the scan-
ner stops for activity on the SWPR
object while scanning.
Fav Yes or No
When Yes, the SWPR object is a
member of the Favorites Scan List.
EXPERT BELOW
Atten On or Off
When on, applies 20 dB of at-
tenuation to all hits received on
the SWPR search. Useful in areas
where interference from nearby
strong signals is present.
Delay On or Off
Controls whether a Delay is used
to wait for reply traffic after a trans-
mission on the SWPR search.
Delay Time 1-200
Sets the amount of time (in 100
millisecond intervals) for the wait
for reply delay if Delay is On, e.g.,
20=2 seconds.
Zeromatic On or Off
When on, enhances the scan-
ner’s ability to lock on to the actual
center frequency of a search hit
instead of an adjacent frequency.
To Next Page
Loading...
