GREER Company MicroGuard 586 Operation/Setup Manual

GREER Company
1918 East Glenwood Place
Santa Ana CA 92705
Page 12 of 44
MicroGuard
®
586 Operation/Setup Manual
W458200 REV C 10/29/02
Configuration Selection
Configuration selection is required upon system power
up; however, it can also be entered
by pressing the setup key.
• The first phase allows selection of the stowed
jib code.
Note:
If no stowed jib options are available, this
selection option is skipped.
• The current stowed jib code will be flashing.
The description of the jib is displayed on the bottom
of the display.
• To select a different stowed jib, use the display
select arrow keys to display the desired option.
• Press the setup key to move to the
next stage.
The current configuration appears at the
bottom of the display.
The configuration code will flash.
• To change the configuration code, use the display
select arrows to show the desired option.
• Press the setup key to select and move on to the
next stage.
OK
DISPLAY
SETUP
SETUP CODE
STOP
RATED CAPACITY
MG-586
!
SELECT
CONTRAST
Stowed Jib

GREER Company MicroGuard 586 Specifications

General

Brand	GREER Company
Model	MicroGuard 586
Category	Touch Panel
Language	English