GREER Company MicroGuard 586 - Boom Length Trim

GREER Company
1918 East Glenwood Place
Santa Ana CA 92705
Page 39 of 44
MicroGuard
®
586 Operation/Setup Manual
W458200 REV C 10/29/02
Boom Length Trim
The system is factory pre-calibrated for Extension
and Length. A trim function is provided to allow for
mechanical tolerances of the Extension Reel drum.
With the boom still fully retracted, check that the
displayed length is the same as the specified
retracted length for the crane.
1. Boom up to 60 degrees and then telescope
the boom out to fully extended. Make sure
that the boom goes out all of the way to fully
extended.
2. Check that the displayed length is the same
as the specified maximum boom length for
the crane.
3. If the displayed length does not match the
maximum boom length specified for the
crane, press the SETUP/OK button. The
system will automatically correct the length.
4. If the displayed length does not match the
maximum boom length specified for the
crane, press the SETUP/OK button. The
system will automatically correct the length.
OK
DISPLAY
SETUP
STOP
RATED CAPACITY
MG-586
!
SELECT
CONTRAST
With the boom fully retracted, the displayed length
should be the same as the specified retracted
length for the crane.
OK
DISPLAY
SETUP
STOP
RATED CAPACITY
MG-586
!
SELECT
CONTRAST
With the boom fully extended, the displayed length
should be the same as the specified fully extended
length for the crane.
OK
DISPLAY
SETUP
STOP
RATED CAPACITY
MG-586
!
SELECT
CONTRAST
To make the length match the specified
maximum length of the crane, press OK.