GREER Company
1918 East Glenwood Place
Santa Ana CA 92705
Page 18 of 44
MicroGuard
®
586 Operation/Setup Manual
W458200 REV C 10/29/02
WARNING
!
Alarm Override
The alarm override button is used to temporarily
silence the current audible alarms and to disable
the automatic motion cutout operation built into the
System for protection.
The audible alarm will sound following any new occurence of alarm. Overriding the audible alarm only cancels the audible
warning for current alarms.
To deactivate the audible alarms, press the override button. Continue to hold the button down for 5 seconds to cancel any
existing motion cuts. The override button must be held down to continue overriding the motion cut.
The alarm override button should be used with caution. Automatic audible alarms warning
against overload, two-block dangers, and hazardous tipping conditions are temporarily
silenced when this option is activated. Motion cutout may also be discontinued.
OK
DISPLAY
SETUP
SETUP CODE
STOP
RATED CAPACITY
MG-586
!
SELECT
CONTRAST
Cancel
To Next Page
Loading...
