GREER Company MicroGuard 586 - Parts-Of-Line

GREER Company
1918 East Glenwood Place
Santa Ana CA 92705
Page 13 of 44
MicroGuard
®
586 Operation/Setup Manual
W458200 REV C 10/29/02
• The current number of parts-of-line is
now flashing.
• To change the parts-of-line, use the display
select arrow keys to display the desired
number.
• To move to the next stage, press the
setup key.
Note: Some configurations allow only single
part-of-line operation.
In these cases, the whole parts-of -line selection
phase will be skipped and the parts-of-line will be
set to 1.
Once the correct parts-of-line are entered, the
system will exit the configuration mode and
return to the normal working screen.
OK
DISPLAY
SETUP
SETUP CODE
STOP
RATED CAPACITY
MG-586
!
SELECT
CONTRAST
Parts of line