Baserunner V6 User Manual
Rev0
manufacturer and motor model number from the new window. Clicking on “Apply”
will return you to the “Basic Setup” tab with all the motor’s parameter fields
populated to their correct values.
Install these new settings to the Baserunner V6 via the “Save Parameters”
button.
Apply some throttle and your motor should run smoothly. If it does not run as
expected, or you are moving to a system with a motor model that does not have
a premade default file, see section 7.1 Motor Autotune.
6.3 Pedal Sensor Defaults (Superharness Only)
PAS Setup tab
NOTE: This section only applies to Superharness setups where a pedal sensor
is plugged into the controller's 6 pin PAS plug. For a Cycle Analyst system, the
pedal sensor behaviour is entirely managed by the CA3 and the Baserunner V6
is not involved.
The PAS Setup tab allows you to manage the pedal sensor control parameters.
With a pedal sensor from Grin, simply select the matching sensor from the preset
dropdown menu and all relevant parameters will be updated along with default
assist levels.
To Next Page
Loading...
