Baserunner V6 User Manual
Rev0
This minimal approach with a PAS sensor does not provide for any means to
adjust the assist level outside of reprogramming the controller. For that reason it
has limited usefulness and is not recommended. A display unit with up/down
buttons is required to vary the amount of assist while riding.
3.4 Network Control - Advanced
There is a 4
th
option, which is to control the Baserunner V6 entirely by digital
commands over the Modbus network through either of the two serial ports (TRRS
jack or Tx + Rx on Main9). This option is available to technical users with existing
firmware and software expertise. Grin can provide the basic protocol
documentation on request, but provides no hand-holding or support beyond that.
4 Controller Mounting
The Baserunner V6 controllers can be installed either by mounting inside a
downtube battery cradle or externally on the bike.
4.1 Battery Cradle Mount
The Baserunner's low profile allows it to just fit inside a modified controller
housings of both Reention and Hailong downtube battery casings.
To Next Page
Loading...
