Groen CC20-E - Eprom (

SERVICE CODES
6-15
Service Code 4
If service code 4 is displayed, refer to the following information block and
troubleshooting table. Read the information block before making a service call,
and use
Table 4 if a service call is required.
Code 4: Indicates a problem in the air temperature probe circuit.
Service Code Information Block
Part Number
Description CC10-E CC20-E CC10-G CC20-G
Air Temperature Probe Kit 071235 071235 *090827 090827
Drain/Air T
emperature 073273 076495 085172 090705
Probe Wire Harness
Relay Board 112966 112964 112964 112964
Control Panel
Single Oven
Cook Only 112960 112960 112960 112960
Cook and Hold 112961 112961 ________ _______
Double-Stacked
Top, Cook Only 112960 112960 112960 112960
Bottom, Cook Only 112960 112960 112960 112960
Top, Cook and Hold 112961 112961 ________ ________
Bottom, Cook and Hold 112961 112961 ________ ________
EPROM 112954 112955 112957 112957
ASK THE CUSTOMER: Ask the customer to reset the solid state controls (see page 6-3). Select
Oven mode. If code 4 reappears, a service call is required. Also ask the
customer for the oven type (model and serial numbers) and what type of
control panel is installed on the unit (Cook only, or Cook and Hold option).
If the unit is a CC10-E, find out if it is a single or double-stacked unit.
Remember, for the CC10-E ovens, control panels cannot be interchanged
between single and double-stacked ovens, nor can they be interchanged
between the upper and lower ovens of a double-stacked unit.
CAN OVEN BE Yes, in Steam mode only.
OPERATED BEFORE
SERVICE?
PARTS TO TAKE ON NOTICE: Be sure to take the Service Manual and the T-Cal Box (old electronics)
SERVICE CALL: (P/N 074821) with you on the service call. Use only Groen Certified parts.
(Revised 1/02)