SERVICE CODES
6-19
Service Code 6
If service code 6 is displayed, refer to the following information block and
troubleshooting table. Read the information block before making a service call,
and use
Table 6 if a service call is required.
Code 6: Indicates a problem in the boiler temperature probe circuit.
Service Code Information Block
Part Number
Description CC10-E CC20-E CC10-G CC20-G
Boiler Temperature Probe Kit 077804
083416 085187 085187
Boiler Temperature Probe Wire ________ ________ 090704 090704
Harness
Relay Board 112966 112964 112964 112964
Control Panel
Single Oven
Cook Only 112960 112960 112960 112960
Cook and Hold 112961 112961 ________ _______
Double-Stacked
Top, Cook Only 112960 112960 112960 112960
Bottom, Cook Only 112960 112960 112960 112960
Top, Cook and Hold 112961 112961 ________ ________
Bottom, Cook and Hold 112961 112961 ________ ________
EPROM 112954 112955 112957 112957
ASK THE CUSTOMER: Ask the customer to reset the controls (see page 6-3). Select Steam mode.
If code 6 reappears, a service call is required. Also ask the customer for the
oven type (model and serial numbers) what type of control panel (Cook only
or Cook and Hold option) is installed on the unit. If the unit is a CC10-E, find
out if it is a single or double-stacked unit. Remember, for the CC10-E ovens,
control panels cannot be interchanged between single and double-stacked
ovens, nor can they be interchanged between the upper and lower ovens of a
double-stacked unit.
CAN OVEN BE Yes, in Oven mode only.
OPERATED BEFORE
SERVICE?
PARTS TO TAKE ON NOTICE: Be sure to take the Service Manual and the T-Cal Box (old electronics)
SERVICE CALL: (P/N 074821) with you on the service call. Use only Groen Certified parts.
(Revised 1/02)
To Next Page
Loading...
