Groen CC20-E User Manual

SERVICE CODES
6-23
Service Code 8
If service code 8 is displayed, refer to the following information block and
troubleshooting table. Read the information block before making a service call,
and use
Table 8 if a service call is required.
Code 8: Indicates that the boiler has not drained.
Service Code Information Block
Part Number
Description CC10-E CC20-E CC10-G CC20-G
Drain Valve 071234 071234 071234 071234
Silicone Hose 071275 080361
085148 090741
(Short)
085149
(Long)
Relay Board 112966 112964 112964 112964
Control Panel
Single Oven
Cook Only 112960 112960 112960 112960
Cook and Hold 112961 112961 ________ _______
Double-Stacked
Top, Cook Only 112960 112960 112960 112960
Bottom, Cook Only 112960 112960 112960 112960
Top, Cook and Hold 112961 112961 ________ ________
Bottom, Cook and Hold 112961 112961 ________ ________
EPROM 112954 112955 112957 112957
ASK THE CUSTOMER: Ask the customer to reset the controls (see page 6-3). Select Steam mode.
If code 8 reappears, a service call is required. Also ask the customer for
oven type (model and serial numbers) and what type of control panel
(Cook only, or Cook and Hold option) is installed on the unit. If the unit is a
CC10-E, find out if it is a single or double-stacked unit. Remember, for the
CC10-E ovens, control panels cannot be interchanged between single and
double-stacked ovens, nor can they be interchanged between the upper and
lower ovens of a double-stacked unit.
CAN OVEN BE Yes. Oven mode only.
OPERATED BEFORE
SER
VICE?
PARTS TO TAKE ON NOTICE: Be sure to take the Service Manual and the T-Cal Box (old electronics)
SERVICE CALL: (P/N 074821) with you on the service call. Use only Groen Certified parts.
(Revised 1/02)

Groen CC20-E Specifications

General

Brand	Groen
Model	CC20-E
Category	Oven
Language	English