Maintenance
Replacement Procedures
8-32
Door Reversing Procedure (continued)
18. Close oven door and operate oven in the Steam mode. If oven fan does not
operate, check location of door magnet and try Steam mode operation again.
If fan operation problem still exists, refer to the Troubleshooting section of this
manual.
19. Allow oven to operate in Steam mode for approximately 5 minutes, then check
for leaks. If there are no leaks, oven is ready for operation. If there are leaks
around the door, recheck door alignment, and if necessary, door gasket
installation. See page 8-5.
(Revised 1/02)
To Next Page
Loading...
