ASTM Ecoflex
®
Rubber End Cap, Single
Submittal Information
Revision C: Feb. 3, 2014
Manufacturer’s Representative:
EPDM (ethylene propylene diene monomer) rubber
Product Information and Application Use
Use the EPDM Rubber End Cap to seal the exposed insulation between the
jacket and service pipe when cutting pipe to make a connection. Designed to
support system integrity, Ecoflex
®
End Caps are required on all exposed
ends of Ecoflex pipes to avoid ground water contamination.
End Cap, ¾" and 1" PEX Pipe with
2.7" Jacket
5012775, 5012710,
5212775, 5212710
End Cap, 1" and 1¼" PEX Pipe with
5.5" Jacket
5015510, 5015513,
5215510, 5215513
End Cap, 1¼", 1½" and 2" HDPE Pipe
with 5.5" Jacket
5115513, 5115515,
5115520
End Cap, 1½", 2", 2½" PEX and 3"
HDPE Pipe with 6.9" Jacket
5016915, 5016920,
5016925, 5116930,
5216915, 5216920
End Cap, 3", 3½", 4" PEX and 4" HDPE
Pipe with 7.9" Jacket
5017930, 5017935,
5017940, 5117940,
5217930
The End Cap includes an O-ring and clamp device for a water-tight installation. Slip the End Cap on the jacket pipe and ensure that the O-ring
stays in place. Refer to the Uponor Pre-insulated Pipe Systems Design and Installation Manual for more information.
Pre-Insulated Pipe Systems
Radiant Heating and Cooling Systems
Snow and Ice Melting Systems
Permafrost Prevention Systems
Turf Conditioning Systems
Uponor, Inc.
5925 148
th
Street West
Apple Valley, MN 55124 USA
Phone: 800.321.4739
Fax: 952.891.2008
www.uponorpro.com
Uponor Ltd.
2000 Argentia Rd., Plaza 1, Ste. 200
Mississauga, ON L5N 1W1 CANADA
Phone: 888.994.7726
Fax: 800.638.9517
www.uponorpro.com
Jackson National Life phase 3.1
To Next Page
Loading...
