GSE 355 - 3.0 Operation; 3.1 Entering a Tare Value (Model 350); 3.2 Entering a Tare Value (Model 355)

AWT35‐500349|June2009 Page10
3.0 Operation
The Model 350 and 355 can operate in a variety of modes such as check-weighing, parts counting and filling
etc. The functions described in this section are not available until enabled within the setup parameters.
Contact your GSE distributor to configure the indicator for a specific operation.
3.1 Entering a Tare Value (Model 350)
If a tare value is known, it is possible to enter that value into the tare register if the setup parameter has been
enabled.
1. From the gross or net mode press the ! key until tare is displayed.
2. Use the  key to scroll in the first number.
3. Press the 2 key to move to the next digit.
4. Repeat steps 2 and 3 until the desired number is showing on the display.
5. Press the # key to accept the entered tare value.
3.2 Entering a Tare Value (Model 355)
If a tare value is known, it is possible to enter that value into the tare register if the setup parameter has been
enabled.
1. Enter the known tare value with the numeric keys and press #. The display will access the net mode.
3.3 Enter an ID Number
If the ID parameter has been enabled previously, a number may be entered to print on a ticket. Follow the
instructions below to enter an ID number.
1. Press the  key from the weigh mode. The display will show the current ID number if one has been
entered previously.
2. Key in the desire ID number (numeric and/or alphanumeric) and press 1 (Model 350) or ( (Model
355). This will print a ticket.
-or-
3. If the ID number shown is acceptable simply press 1 (Model 350) or ( (Model 355). This will print a
ticket which includes the entered ID number.