GSE 355 - 3.8 Batch; 3.8.1 Enter a Target

AWT35‐500349|June2009 Page17
3.8 Batch
The standard batch program is used for batching up to three separate items. Ingredients 1 through 3 use
setpoints and pre-acts 1 through 3 respectively. Ingredients are batched one at a time. Free falling product
can be accounted for with the use of pre-act values (PA1 – PA3). This feature must be enabled before
attempting to use.
3.8.1 Enter a Target
Pressing 1 or ( alone allows access to the subsets. PA 1 and PA 2 are the subsets for Targ 1.
3.8.1.1 Model 350
1. Press ! until tArG1 is displayed.
2. Press
 until the first digit of the new target is displayed. Press 2 to accept the number displayed.
Continue this step until the desired number is entered.
Example: Target of 20
Press
 four times
DISPLAY READS X 2
Press
2 to accept the 2 that is displayed
DISPLAY READS X 2 .
Press
 once
DISPLAY READS X 20
Press
1 to accept the target weight as 20
DISPLAY READS X 20
3. Press
1. Once the tare key is pressed, it is possible that PA1 will be displayed if the pre-act parameter
is enabled.
If a value is desired, enter it in the same manner as the target weight was entered above. When the
displayed value is correct, press
1.
If no value is to be entered or PA1 is not displayed, press
1 to go to the next screen.
4. Repeat steps 2 and 3 until all targets and pre-acts are entered. Press
1 to return to the weigh mode.
3.8.1.2 Model 355
1. Press ! until tArG1 is displayed.
2. Key in the desired target value with the numeric keys and press
(.
3. The PA1 value will be displayed. Key the in value with the numeric keys and press
(.
4. Repeat steps 2 and 3 for tArG2, PA2, tArG3 and PA3.
5. Press
! to select the desired weigh mode parameter.