GSE 355 - 3.6 Percentage Checkweigh; 3.6.1 Enter a Target Value

AWT35‐500349|June2009 Page14
3.6 Percentage Checkweigh
This feature is commonly used in checkweigh applications and must be enabled before attempting to use.
After a target weight is entered, upper and lower tolerances are entered as a percentage of the target. Over
and under tolerance values are automatically calculated according to the percentages entered. The desired
target may be based on gross weight, net weight or quantity (if counting is enabled).
3.6.1 Enter a Target Value
3.6.1.1 Model 350
1. Press ! until tArG1 is displayed. If the target value shown is correct, press 1 to go to the PctLo
value. To change the target value, go to step 2.
2. Press
 until the first digit of the new target is displayed. Press 2 to accept the number displayed.
Continue this step until the desired number is entered. Refer to the example below as a reference.
Example: Target of 20
Press
 four times
DISPLAY READS X 2
Press
2 to accept the 2 that is displayed
DISPLAY READS X 2 .
Press
 once
DISPLAY READS X 20
Press
1 to accept the target weight as 20
DISPLAY READS X 20
3. Press
1 to accept the entered value. Once the tare key is pressed, PctLo will be displayed. This is
where the low percentage will be entered. Enter target percentage value in the same manner as the
target weight was entered above. If the displayed value is correct, press
1.
4. Next the PctHi value will be displayed. This is target percentage value for the high percentage. Enter this
value in the same manner as the target weight was entered above. If the displayed value is correct press
!. The display will return to the weigh mode. Press ! to view the desired weigh mode parameter.
3.6.1.2 Model 355
1. Press ! until tArG1 is displayed.
2. Key in the target weight with the numeric keys and press
(.
3. The PctLo value will be displayed. Key the in target percentage value with the numeric keys and press
(.
4. The PctHi value will be displayed. Key the in target percentage value with the numeric keys and press
(.
5. Press
! to select the desired weigh mode parameter.