4. Assembly and Installation
36 PNEG-1156ETL Design III Series Grain Stir-Ator CSA
Center Suspension System
1. The Center Suspension System: Double auger units use a single piece square tube. The triple
auger units use a two (2) piece square tube “T” assembly.
2. For Double Auger Units: Place the attachment link on the single suspension tube into the welded
clevis provided on the yoke head. Fasten with one 1/2" x 2" hex head bolt and hex lock nut. Tighten
with ratcheting hand wrench. (See Figure 4AE.)
Figure 4AE Double Auger
3. For Triple Auger Units: First assemble two (2) piece “T” square tube sections using one 1/2" x 2"
hex head bolt and hex lock nut. Tighten with ratcheting hand wrench. (See Figure 4AF.)
Figure 4AF Triple Auger
NOTE: Be sure small loops on the suspension tube ends are always down.
To Next Page
Loading...