GST GST102A - 1.2.2 Batteries; 1.2.3 Load of Power Supply; 1.2.4 Detection Zone; 1.2.5 Output Interface

GST102A/GST104A/GST108A/GST116A
Conventional Fire Alarm Control Panel
Installation and Operation Manual
Page III
2.4 Zone Input Connection .................................................................................................... 17
2.4.1 Using end of line resistor .......................................................................................... 17
2.4.2 Using an Active End of Line Unit .............................................................................. 17
2.5 Sounder/Fire Alarm Output Connections......................................................................... 17
Chapter 3 System Setup ........................................................................................................... 18
3.1 Setting Access Levels ...................................................................................................... 18
3.1.1 Setting Access Level I ............................................................................................... 18
3.1.2 Setting Access Level II .............................................................................................. 18
3.1.3 Setting Access Level III ............................................................................................. 18
3.2 Setup of the Sounder / Alarm Output .............................................................................. 18
3.3 Disablement of a Zone or Output .................................................................................... 19
3.3.1 Use of Disablement Function .................................................................................... 19
3.3.2 Operation Basic Steps – Generally used for individually Disabling Zones or Sounder
/Alarm Outputs when the panel is in normal operation mode............................................ 20
3.3.3 Quick Disablement Function – Generally used for group Disablements of Zones or
Sounder Outputs when the panel is in Alarm mode. ......................................................... 20
3.4 Setting Test Mode ............................................................................................................ 21
3.4.1 Use of Test Mode ...................................................................................................... 21
3.4.2 Operation Steps ........................................................................................................ 21
3.4.3 Test zone output mode .............................................................................................. 22
3.5 Programming Output Modes ........................................................................................... 22
3.5.1 Setting Zone “With Manual Call Point”...................................................................... 22
3.5.2 Setting Associated Sounders to a Zone ................................................................... 23
3.5.3 Setting Delay Time of Alarm Output.......................................................................... 24
3.5.4 Sounder Output Mode ............................................................................................... 24
3.6 Supervisory Mode ............................................................................................................ 26
3.6.1 Use of Supervisory Function ..................................................................................... 26
3.6.2 Programming a Zone to Supervisory ........................................................................ 26
3.7 Setting Auxiliary Functions .............................................................................................. 27
3.8 Ground Fault Detection.................................................................................................... 27
3.9 Auxiliary Power Setting .................................................................................................... 27
3.10 Restore Default Settings ................................................................................................ 28
Chapter 4 Operation Instructions .............................................................................................. 29
4.1 Working State Description ............................................................................................... 29