GST GST200 User Manual

GST GST200 Specifications

General

Brand	GST
Model	GST200
Category	Control Panel
Language	English

Summary

Installation Precautions

Adhere to Regulations and AHJ

Install equipment according to instructions and appropriate national/local regulations.

Service by Trained Specialist

GST200 FACP shall only be installed and serviced by trained specialist.

Disconnect Power Before Servicing

Disconnect all power sources before servicing to prevent equipment damage.

Chapter 2 Technical Specifications

Operating Voltage and Current

Standby Batteries

Detecting Loop Parameters

Output Loop Parameters

Chapter 3 Structure and Configuration

Keypad and Panel Operations

Chapter 4 Installation

Installation Preparation

Power and Device Connections

Details AC power, battery, and field device connection procedures.

Loop and Communication Wiring

Inspection, Registration, and Definition

Covers connection inspection, device registration, and definition.

Field Device Commissioning

Guides on commissioning field devices after installation and definition.

Chapter 5 Display and Disposal of System Information

System Status Displays

Handling Alarms and Faults

Chapter 6 Description of System Operation

Keypad and Basic Operations

System Control and Device Management

Configuration and Administrator Settings

Chapter 7 Standby Battery Calculations

Battery Capacity Calculation Equation

Provides the formula for calculating required battery capacity.

Battery Calculation Parameters

Defines the parameters used in the battery capacity calculation.

Standby Time Requirements

Specifies the minimum standby and alarm times required by EN 54-4.

Chapter 8 Maintenance

Replacing the Battery

Details the procedure and recommendations for replacing the battery.

Replacing the Fuses

Provides a table listing fuse locations, marks, and rated values.

Troubleshooter Guide

Offers solutions for common problems and their possible causes.