GST GST200 - Setting Work Mode of Printer; Checking All Visual and Audible Indications; Gas Extinguishing Equipment; Burglar Mode Setting

GST200 Intelligent Fire Alarm Control Panel
Installation and Operation Manual
The Intelligent Solution
Page 37
6.3.5 Setting work mode of printer
Press PRINT to enter print mode as shown in Fig. 6-25.
*Print Mode*
1 Disable
2 Only Fire
3 All History
Fig 6-25
Entering “1”, printing will be disabled.
Entering “2”, only fire alarm records are printed.
Entering “3”, you can print the current messages while browsing history records by
pressing PRINT.
6.3.6 Checking all visual and audible indications
In normal monitoring state, you can check all visual and audible indications of the FACP
by pressing SELF TEST.
6.3.7 Gas Extinguishing Equipment
Pressing MODE, you can set up gas extinguishing equipment. The screen is shown in
Fig. 6-26.
Fig. 6-26
*Extinguish*
1 Disable
2 Enable
Entering “1” means not to start gas extinguishing equipment by C&E automatically.
Entering “2” means to start gas extinguishing equipment by C&E automatically.
EXTINGUISHING SYSTEM PERMIT LED will illuminate.
6.3.8 Burglar Mode Setting
Pressing SEC, you can set up burglar mode. The screen is shown in Fig. 6-27.