GST200 Intelligent Fire Alarm Control Panel
Installation and Operation Manual
The Intelligent Solution
Page 38
*Burglar Mode*
1 Disable
2 Enable
3 Only Night
Fig. 6-27
If “1” is input, burglar mode is disabled. The system doesn’t respond to the action of
security modules.
If “2” is input, burglar mode is enabled. The system responds to the action of security
modules.
If “3” is input, burglar mode is only effective during night. The screen will then show a
request for on and off time. Its window is shown in Fig. 6-28.
BURGLAR ON/OFF TIME
Please Input
00:00 ON
00:00 OFF
Fig. 6-28
If you input 19 at highlighted position, then press TAB, and input 30, the ON time of
burglar mode is 19: 30. Pressing TAB again, you can set up the OFF time. Input 07,
press TAB, then input 30 again, the OFF time is 07: 30. Pressing ENTER to confirm,
and the system returns to the setting screen.
6.4 Instructions for System Administrator (Manager Password
Required)
Press SYSTEM to enter the system setting screen. The screen is shown in Fig. 6-29.
Fig. 6-29
*S
To Next Page
Loading...
