GST GST200 - Preface en 54 Information

GST200 Intelligent Fire Alarm Control Panel
Installation and Operation Manual
The Intelligent Solution
Page 2
Preface EN 54 Information
 GST200 Intelligent Fire Alarm Control Panel (FACP) complies with the
requirements of EN 54-2: 1997 and EN 54-4: 1997. In addition to the basic
requirements of these standards, the panel conforms to the following
optional requirements.
EN 54
√
Option EN 54-2 Clause
Indication Fault signals from points 8.3
Delays to Outputs 7.11
Coincidence detection 7.12
Control
Disablement of each addressable points 9.5
Output to fire alarm devices 7.8
Outputs
Output to automatic fire protection equipment 7.10
 The power supply of GST200 FACP complies with EN 54-4 requirements.
EN 54
√
AC-DC 100W Power Supply Functions EN 54-4 Clause
Derive Power supply from main source 5.1
Derive Power supply from a standby power battery 5.2
Charge and monitor the standby battery source 5.3
Detect & signal power supply faults 5.4
 In addition to functions required by EN54-2, the panel supports a number
of ancillary functions that are not required. These are outlined below:
EN 54
N/A
Ancillary Function Manual Section
P-9901 Printer 3.2.2
RS232 output 2.3 & 3.2.2
GST852RP Repeater Panel 3.3.6
GstDef2.0 Defining Tool 3.4
Fire alarm output 4.4.3.3
RS485 output 2.3 & 4.4.3.5
Class change 4.4.3.1