Working with the mega macs PC
mega macs PC
Vehicle Selection
5. Select the requested manufacturer.
CAUTION
Pulling off of the PC VCI when actuating the clutch
Risk of injury or material damage
Proceed as follows before starting:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the PC VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the PC VCI to the vehicle.
6. Connect the PC VCI to the vehicle's diagnostic connector.
Both LEDs of the PC VCI flash. The PC VCI is ready for operation.
7. Confirm the selection with
.
Data download is in progress. Communication with the vehicle is established.
8. Regard the window with infos and instructions.
The message VIN could not be read out appears if the VIN could not be read out.
9. Confirm the window with infos and instructions with
where necessary.
10. Repeat steps 5 to 8 where necessary.
11. Confirm the window with infos and instructions with
.
Communication to vehicle is being established. A drop-down list appears.
The corresponding vehicles are selected from the database.
12. Double-click the required vehicle to select.
13. Perform steps 8 to 11 as described in the section Vehicle selection (Page 55).
56
To Next Page
Loading...