GUTMANN mega macs PC - Service Reset; Performing Manual Service Resets

mega macs PC
Working with the mega macs PC
Diagnostics
11.5.5 Service reset
Use this menu to reset service intervals provided that this function is supported by the vehicle. Here you will find a
description for the manual reset or the mega macs PC performs the reset automatically.
11.5.5.1 Performing Manual Service Resets
CAUTION
Pulling off of the PC VCI when actuating the clutch
Risk of injury or material damage
Proceed as follows before starting:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with infos and instructions.
Proceed as follows to perform the manual service reset:
1. Perform steps 1 to 11 as described in the section Vehicle selection (Page 55).
CAUTION
Pulling off of the PC VCI when actuating the clutch
Risk of injury or material damage
Proceed as follows before starting:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the PC VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the PC VCI to the vehicle.
2. Connect the PC VCI to the vehicle's diagnostic connector.
Both LEDs of the PC VCI flash. The PC VCI is ready for operation.
3. Select Diagnostics > Function > Service reset.
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
• Functions
• Assemblies
• Systems
• Data
4. Select the requested system.
5. Observe the info window.
6. Call up the >Information< tab.
7. Follow the instructions on the screen.
8. Start the manual service reset with
.
69