GUTMANN mega macs PC - 12 Applications; Calculator; Activating the Calculator; Pass Thru

mega macs PC
Applications
Calculator
12 Applications
An overview of the available applications is shown here.
12.1 Calculator
Perform general calculations here.
12.1.1 Activating the Calculator
Proceed as follows to make calculations:
1. Select >Applications< in the main menu.
2. Select Calculator with
.
3. Perform the requested calculations.
12.2 Pass Thru
Here you can transmit data from the shop PC to the vehicle in the shop.
12.2.1 Calling Up PassThru
Perform the steps as described in section Executing the HGS PassThru Software to call up PassThru.
12.3 Calculations
Here you can perform the the following conversions:
• Fuel consumption
• Piston speed
• Current/power output/resistance
• Conversion of technical units
12.3.1 Calling Up Calculations
Proceed as follows to call up calculations:
1. Select >Applications< in the main menu.
2. Select Calculations with
.
3. Select the required calculation type.
4. Select the required size.
5. Open the virtual keypad with
.
6. Enter the requested value.
89