mega macs PC
Working with the mega macs PC
Diagnostics
4. Select the requested assembly.
5. Select the requested system.
6. Observe the information and instructions windows.
7. Call up the >Information< tab.
8. Follow the instructions on the screen.
9. Start the automatic basic setting with
.
10. Regard the window with infos and instructions.
11. Confirm the window with infos and instructions with
.
Communication to vehicle is being established.
12. Select further sub-categories where necessary.
13. Confirm the selection with
.
14. Regard the window with infos and instructions.
15. Confirm the window with infos and instructions with
.
Communication to vehicle is being established. Basic settings are made automatically.
The message Basic setting successfully done. appears if the basic setting was successful.
11.5.7 Codings
Here you can code components and ECUs. Codings are necessary, if components were replaced or additional functions
in an electronic system must be activated.
11.5.7.1 Performing Manual Coding Procedures
WARNING
The ECU is not coded or is incorrectly coded
Death or severe injuries of persons due to improper or even wrong ECU operation
Material damage of the vehicle or the ambient area
Regard the following when performing coding procedures:
• Some working procedures require a specific training, e.g., working on the airbag.
• Regard the window with infos and instructions.
Proceed as follows to perform manual coding:
73
To Next Page
Loading...