GUTMANN mega macs PC - Performing a Battery Test; Preconditions for Saving Test Results in the Car History; Saving Test Results in the Car History

mega macs PC
Optional HGS Tools
Battery Diagnostics
5. Select >System test<.
6. Open the list under Temperature measurement with
.
7. Select the required type of temperature measurement.
8. Repeat steps 6 to 7 for another selection.
9. Open the virtual keypad under Cold cranking amps [A] with
where necessary.
10. Enter a value.
11. Confirm your entry with
.
12. Start the function System test under Diagnostic type with
.
The connection to the BPC-Tool is established.
The system test is started.
From here, the system test is controlled using the keys on the BPC-Tool (see operating instructions of the BPC-Tool).
A summary of the system test is displayed on the BPC-Tool and is automatically imported into the device.
13.1.2 Performing a Battery Test
Proceed as follows to perform the battery test:
1. Connect the BPC-Tool to the battery (see operating instructions for the BPC-Tool).
2. Insert the electrical plug connection of the clamp meter into the ST3 connector of the BPC-Tool with the arrow
pointing up.
3. Select >Optional HGS Tools< in the main menu.
4. Select Battery diagnostics with
.
5. Select >Battery test<.
6. Open the list under Battery position with
.
7. Select >In the vehicle< or >Outside the vehicle<.
8. Repeat steps 6 to 7 for another selection.
9. Open the virtual keypad under Cold cranking amps [A] with
where necessary.
10. Enter a value.
11. Confirm your entry with
.
12. Start the Battery diagnostics with
.
The connection is established and the device searches for the BPC-Tool.
The battery test is started.
From here, the system test is controlled using the keys on the BPC-Tool (see operating instructions of the BPC-Tool).
13.1.3 Preconditions for Saving Test Results in the Car History
Ensure the following to save the most recent test results of the system and battery test in the Car History:
• Required vehicle selected in the mega macs PC software.
• BPC-Tool on.
• BPC-Tool connected to the mega macs PC software.
13.1.4 Saving Test Results in the Car History
Proceed as follows to save the most recent test result from the battery test or system test in the Car History:
93