2-11
Figure 2-9 Mounting the switch in the rack (front mounting brackets at the power supply
side)
Rack-mounting the switch by using front and rear mounting
brackets
Attaching the front mounting brackets and shoulder screws to the switch
You can attach the front mounting brackets at the port-side or power supply-side mounting position.
The following uses port-side mounting as an example. The power-side mounting is similar.
To attach the front mounting brackets and shoulder screws to the switch:
1. Align the round holes in the wide flange of one front mounting bracket with the screw holes in
the port-side mounting position on one side of the chassis. See Figure 2-10.
2. Use M4 screws (supplied with the switch) to attach the front mounting bracket to the chassis.
3. Repeat the proceeding two steps to attach the other front mounting bracket to the chassis.
4. Unpack the shoulder screws. Attach a shoulder screw to one of the two installation positions as
red-marked in Figure 2-10 at both sides of the chassis.
Figure 2-10 Attaching the front mounting brackets and shoulder screws to the chassis
To Next Page
Loading...
