H3C S5560S-EI Series User Manual

4-38
GE SFP
transceiver
module and
cable
Central
wavelength
(nm)
Connector
Cable/Fiber
type and
diameter (µm)
Modal
bandwidth
(MHz × km)
Max
transmission
distance
SFP-GE-LH70-
SM1550-BIDI
TX: 1550 nm
RX: 149 nm
LC
Single-mode,
9/125
N/A
70 km (43.49
miles)
SFP cable
SFP-STACK-Kit N/A 1.5 m (4.92 ft)
IMPORTANT:
The
SFP-GE-LX-SM1310-BIDI and SFP-GE-LX-SM1490-BIDI transceiver modules, the
SFP
-GE-LH40-SM1310-BIDI and SFP-GE-LH40-SM1550-BIDI transceiver modules, and the
SFP
-GE-LH70-SM1490-BIDI and SFP-GE-LH70-SM1550-BIDI transceiver modules must be used
in pairs
. For example, if one end uses an SFP-GE-LX-SM1310-BIDI transceiver module, the other
end must use an SFP-GE-LX-SM1490-BIDI transceiver module.
NOTE:
•
As a best practice, use only H3C SFP transceiver modules and cables for the SFP ports.
•
The H3C SFP transceiver modules and cables available for the SFP ports
are subject to change
over time. For the most recent list of SFP transceiver modules and cables available for the
SFP
port, contact your H3C Support or marketing staff.
•
For the specifications of H3C SFP transceiver modules and cables, see H3C Transceiver
Modules User Guide.
SFP+ port
The following switches each provide four fixed SFP+ ports on the front panel:
•
S5560S-28F-EI
•
S5560S-52F-EI
•
S5560S-28S-EI
•
S5560S-52S-EI
•
S5560S-28S-PWR-EI
•
S5560S-52S-PWR-EI
•
S5130S-28C-HI
•
S5130S-28S-HI
•
S5130S-52S-HI
•
S5130S-28C-PWR-HI
•
S5130S-28S-PWR-HI
•
S5130S-28S-UPWR-HI
•
S5130S-52S-PWR-HI
The S5130S-52C-HI and S5130S-52C-PWR-HI switches each provide two fixed SFP+ ports on the
front panel.
To connect peer SFP+ ports over a long distance, use SFP/SFP+ transceiver modules and fibers. To
connect peer SFP+ ports over a short distance, use SFP+ cables. You can install the GE SFP
transceiver module in Table4-5, 10-GE SFP+ transceiver modules in Table4-6, and 10-GE SFP+
cables in Table4-7 in the SFP+ ports.

H3C S5560S-EI Series Specifications

General

Brand	H3C
Model	S5560S-EI Series
Category	Switch
Language	English