4
display ipv6 nd suppression vsi
Use display ipv6 nd suppression vsi to display ND flood suppression entries.
Syntax
display ipv6 nd suppression vsi [ name vsi-name ] [ slot slot-number ]
[ count ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
name vsi-name: Specifies a VSI by its name, a case-sensitive string of 1 to 31 characters. If you
do not specify a VSI, this command displays entries for all VSIs.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a
member device, this command displays entries on the master device.
count: Displays the number of ND flood suppression entries that match the command.
Examples
# Display ND flood suppression entries.
<Sysname> display ipv6 nd suppression vsi
IPv6 address MAC address VSI name Link ID Aging (min)
1000::2 000f-e201-0101 vsi1 0x70000 5
1000::3 000f-e201-0202 vsi1 0x80000 5
1000::4 000f-e201-0203 vsi2 0x90000 5
# Display the number of ND flood suppression entries.
<Sysname> display ipv6 nd suppression vsi count
Total entries: 3
Table 2 Command output
Link ID Link ID that uniquely identifies an AC or a VXLAN tunnel on a VSI.
Aging (min)
Remaining lifetime (in minutes) of the ND flood suppression entry. When the
timer expires, the entry is deleted.
Related commands
ipv6 nd suppression enable
reset ipv6 nd suppression vsi
display l2vpn mac-address
Use display l2vpn mac-address to display MAC address entries for VSIs.
Syntax
display l2vpn mac-address [ vsi vsi-name ] [ dynamic ] [ count | verbose ]
To Next Page
Loading...
Need help?
General