H3C S5560X-EI Series Command Reference

42
Default
Dynamic ND entry synchronization is disabled for distributed VXLAN IP gateways.
Views
System view
Predefined user roles
network-admin
Usage guidelines
When local ND proxy is enabled on distributed VXLAN IP gateways, each gateway learns ND
information independently. A gateway does not forward ND packets destined for its local VSI
interfaces to other gateways. For distributed VXLAN IP gateways to have the same ND entries, you
must enable dynamic ND entry synchronization.
A controller or the EVPN feature can also synchronize ND entries among distributed VXLAN IP
gateways. When you use a controller or the EVPN feature, do not enable dynamic ND entry
synchronization.
Examples
# Enable dynamic ND entry synchronization for distributed VXLAN IP gateways.
<Sysname> system-view
[Sysname] ipv6 nd distributed-gateway dynamic-entry synchronize
Related commands
distributed-gateway local
local-proxy-nd enable (Layer 3—IP Services Command Reference)
mac-address
Use mac-address to assign a MAC address to a VSI interface.
Use
undo mac-address to restore the default.
Syntax
mac-address mac-address
undo mac-address
Default
The MAC address of VSI interfaces is the bridge MAC address + 26.
Views
VSI interface view
Predefined user roles
network-admin
Parameters
mac-address: Specifies a MAC address in H-H-H format.
Examples
# Assign MAC address 0001-0001-0001 to VSI-interface 100.
<Sysname> system-view
[Sysname] interface vsi-interface 100
[Sysname-Vsi-interface100] mac-address 1-1-1

H3C S5560X-EI Series Specifications

General

Brand	H3C
Model	S5560X-EI Series
Category	Switch
Language	English