36
Parameters
text: Specifies a description, a case-sensitive string of 1 to 255 characters.
Examples
# Configure the description as gateway for VXLAN 10 for VSI-interface 100.
<Sysname> system-view
[Sysname] interface vsi-interface 100
[Sysname-Vsi-interface100] description gateway for VXLAN 10
display interface vsi-interface
Use display interface vsi-interface to display information about VSI interfaces.
Syntax
display interface [ vsi-interface [ vsi-interface-id ] ] [ brief
[ description | down ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vsi-interface [ vsi-interface-id ]: Specifies VSI interfaces. If you specify a VSI
interface, this command displays information about the specified interface. If you specify only the
vsi-interface keyword, this command displays information about all VSI interfaces. If you do
not specify the
vsi-interface [ vsi-interface-id ] option, this command displays
information about all interfaces. Make sure the specified VSI interfaces have been created on the
device.
brief: Display brief interface information. If you do not specify this keyword, the command displays
detailed interface information.
description: Displays complete interface descriptions. If you do not specify this keyword, the
command displays only the first 27 characters of interface descriptions.
down: Displays interfaces that are physically down as well as the down reason. If you do not specify
this keyword, the command does not filter output by physical interface state.
Examples
# Display information about VSI-interface 100.
<Sysname> display interface vsi-interface 100
Vsi-interface100
Current state: UP
Line protocol state: UP
Description: Vsi-interface100 Interface
Bandwidth: 1000000 kbps
Maximum transmission unit: 1500
Internet address: 10.1.1.1/24 (primary)
IP packet frame type: Ethernet II, hardware address: 0011-2200-0102
IPv6 packet frame type: Ethernet II, hardware address: 0011-2200-0102
Physical: Unknown, baudrate: 1000000 kbps
To Next Page
Loading...
