H3C S5560X-EI Series - Maintenance and troubleshooting; Fixed power module failure

37
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Table 10 Command output
Field
Description
Current state
Physical link state of the interface:
• Administratively DOWN—The interface has been shut down
by using the
shutdown command.
• DOWN—The interface is administratively up, but its physical
state is down.
• UP—The interface is both administratively and physically up.
Line protocol state
Data link layer state of the interface:
• UP—The data link layer protocol is up.
• UP(spoofing)—The data link layer protocol is up, but the link
is an on-demand link or does not exist.
• DOWN—The data link layer protocol is down.
Description Description of the interface.
Bandwidth Expected bandwidth of the interface.
Maximum transmission unit MTU of the interface.
Internet protocol processing: Disabled
The interface is not assigned an IP address and cannot process IP
packets.
Internet address
IP address of the interface. The
primary
attribute indicates that the
address is the primary IP address.
IP packet frame type IPv4 packet framing format.
hardware address MAC address.
IPv6 packet frame type IPv6 packet framing format.
Physical
Physical type of the interface, which is fixed at
Unknown
.
baudrate Interface baudrate in kbps.
Last clearing of counters
Last time when the interface statistics are cleared.
The current software version does not support clearing interface
statistics. This field always displays
Never.
Last 300 seconds input rate Average input rate for the last 300 seconds.
Last 300 seconds output rate Average output rate for the last 300 seconds.
Input: 0 packets, 0 bytes, 0 drops
Incoming traffic statistics on the interface:
• Number of incoming packets.
• Number of incoming bytes.
• Number of dropped incoming packets.
Output: 0 packets, 0 bytes, 0 drops
Outgoing traffic statistics on the interface:
• Number of outgoing packets.
• Number of outgoing bytes.
• Number of dropped outgoing packets.
# Display brief information about all VSI interfaces.