H3C S5560X-EI Series Command Reference

39
distributed-gateway local
Use distributed-gateway local to specify a VSI interface as a distributed gateway to
provide services for the local site.
Use
undo distributed-gateway local to restore the default.
Syntax
distributed-gateway local
undo distributed-gateway local
Default
A VSI interface is not a distributed gateway.
Views
VSI interface view
Predefined user roles
network-admin
Usage guidelines
If a VXLAN uses distributed gateway services, you must assign the same IP address to the VXLAN's
VSI interfaces on different VTEPs. To avoid IP address conflicts, you must specify the VSI interface
on each VTEP as a distributed gateway.
Examples
# Specify VSI-interface 100 as a distributed gateway.
<Sysname> system-view
[Sysname] interface vsi-interface 100
[Sysname-Vsi-interface100] distributed-gateway local
gateway subnet
Use gateway subnet to assign a subnet to a VSI.
Use
undo gateway subnet to remove a subnet from a VSI.
Syntax
gateway subnet { ipv4-address wildcard-mask | ipv6-address
prefix-length
}
undo gateway subnet
{ ipv4-address wildcard-mask | ipv6-address
prefix-length
}
Default
No subnet is assigned to a VSI.
Views
VSI view
Predefined user roles
network-admin
Parameters
ipv4-address: Specifies an IPv4 subnet address in dotted-decimal notation.

H3C S5560X-EI Series Specifications

General

Brand	H3C
Model	S5560X-EI Series
Category	Switch
Language	English