34
Views
VSI interface view
Predefined user roles
network-admin
Parameters
pps: Specifies a rate limit in the range of 1 to 500 pps.
Usage guidelines
VMs have limited capacity to process packets. To prevent packet processing from degrading VM
performance, limit the ARP packet sending rate of the VSI interface for VMs. The VTEP will drop
excess ARP packets if the rate limit is exceeded.
Examples
# Set the ARP packet sending rate limit to 50 pps for VSI-interface 1.
<Sysname> system
[Sysname] interface vsi-interface 1
[Sysname-Vsi-interface1] arp send-rate 50
bandwidth
Use bandwidth to set the expected bandwidth for a VSI interface.
Use
undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) of a VSI interface equals the interface baud rate divided by 1000.
Views
VSI interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth to 10000 kbps for VSI-interface 100.
<Sysname> system-view
[Sysname] interface vsi-interface 100
[Sysname-Vsi-interface100] bandwidth 10000
To Next Page
Loading...
Need help?
General