40
S5820V2-54QS-GE
Figure 50 Front panel
(1) 10/100/1000Base-T autosensing Ethernet port (2) 10/100/1000Base-T autosensing Ethernet port LED
(3) SFP+ port (4) SFP+ port LED
(5) QSFP+ port (6) QSFP+ port LED
(7) System status LED (SYS)
Figure 51 Rear panel
(1) Grounding screw (auxiliary grounding point 2) (2) Management Ethernet port
(3) Console port (4) Fan tray slot 1
(5) Fan tray slot 2 (6) Power module slot 1
(7) Power module slot 2 (8) LINK LED for the management Ethernet port
(9) ACT LED for the management Ethernet port (10) USB port
The S5820V2-54QS-GE switch comes with the power module slots empty and the filler modules for
the slots as accessories. You can install one or two power modules for the switch as needed.
In Figure 51,
two LSVM1AC650 power modules are installed. For more information about installing
and removing a power module, see "Installing/removing a power module."
The S5820V2-54QS-GE switch also comes with the fan tray slots empty. You must install two fan
trays of the same model for the switch. In Figure 51, two LSWM
1FANSC fan trays are installed. For
more information about installing and removing a fan tray, see "Installing/removing a fan tray."
Figure 52
Left side panel
(1) Primary grounding point (2) Auxiliary grounding point 1
To Next Page
Loading...
Need help?
General