2
storage controller in UEFI mode. For more information about how to access the BIOS setup utility
and set the boot mode to UEFI, see the BIOS user guide for the server.
Controller configuration tasks at a glance
To configure controller settings in UEFI mode, perform the following tasks:
Accessing the storage controller configuration screen
Configuring a RAID array
Deleting a RAID array
Rebuilding a RAID array
Viewing physical drive information
Viewing logical drive information
Configuring logical drive media patrol
Viewing namespace information
Viewing storage controller information
Accessing the storage controller configuration screen
1. After the server is powered on or restarts, access the BIOS. Press Delete, Esc, or F2 as
prompted during server POST to open the BIOS setup screen as shown in Figure 1.
For how to navigate screens and modify settings, see the operation instructions at the lower
right corner.
Figure 1 BIOS setup screen
2. Select Advanced > Marvell NVMe Configuration Utility, and press Enter.
To Next Page
Loading...
Need help?
General
