H3C WX Series Configuration Guide

43
Port priority configuration example
Network requirements
As shown in Figure 6 , the AC processes the packets of AP 1, AP 2, and AP 3. Configure
the AC to ensure that:
Incoming packets are assigned local precedence values through priority mapping
based on the port priority of receiving ports.
The default priority mapping tables of the AC are used.
The wireless interface of AP 1 is WLAN-ESS 1, that of AP 2 is WLAN-ESS 2, and that of
AP 3 is WLAN-ESS 3.
Figure 6 Network diagram for trusting port priority configuration
AC
GE 1/0/1
IP network
AP 1
AP 3
AP 2
Configuration procedure
1. Enter system view:
<AC> system-view
2. Disable the service template bound with each WLAN-ESS interface: (Assume that
the WLAN-ESS interfaces are bound with service template 1.)
[Sysname] wlan service-template 1
[Sysname-wlan-st-1] service-template disable
[Sysname-wlan-st-1] quit
3. Set the priority of interface WLAN-ESS 1 to 1:
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] qos priority 1
[AC-WLAN-ESS1] quit
4. Set the priority of interface WLAN-ESS 2 to 3:
[AC] interface WLAN-ESS 2

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English