H3C WX Series Configuration Guide

58
PQ configuration example on WX5002
Table 10 describes the Ethernet interface configuration prerequisites on different WX
series access controllers.
Table 10 Ethernet interface configuration prerequisites
Hardware
Ethernet interface configuration prerequisites
Switches
installed
with
access
controller
modules
Access
controller
modules
LS8M1WCMA0
LSQM1WCMB0
LSBM1WCM2A0
LSRM1WCM2A1
No special requirements. You can directly
configure Ethernet interfaces on the switch.
To configure wireless features during the
configuration process, log in to the access
controller module with the oap connect slot
slot-number command.
LSWM1WCM10
LSWM1WCM20
No special requirements. You can directly
configure Ethernet interfaces on the switch.
To configure wireless features during the
configuration process, log in to the access
controller module with the mcms connect [ slot
slot-number ] system system-name command.
Unified
switches
WX3024
WX3010
WX3008
Use the oap connect slot 0 command on the
access controller engine to log in to the
switching engine.
Access
controllers
WX6103
Use the oap connect slot 0 command on the
active main control board to log in to the switch
interface board.
WX5002
WX5002V2
WX5004
No special requirements. You can directly
configure a GE interface on the access
controller.
Network requirements
As shown in Figure 14 , Client A and Client B get data from Server through the AC.
Configure the AC to preferentially process data from the higher-priority client.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English