H3C WX Series Configuration Guide

49
Configuring traffic policing in policy-based approach
Follow these steps to configure traffic policing in policy-based approach:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a class and enter
class view
traffic classifier tcl-name [ operator { and | or } ]
—
Configure the match
criteria
if-match match-criteria
—
Exit class view
quit
—
Create a behavior and
enter behavior view
traffic behavior behavior-name
—
Configure a traffic
policing action
car cir committed-information-rate [ cbs
committed-burst-size [ ebs excess-burst-size ] ] [ pir
peak-information-rate ] [ green action ] [ red
action ]
Required
Exit behavior view
quit
—
Create a policy and
enter policy view
qos policy policy-name
—
Associate the class with
the traffic behavior in
the QoS policy
classifier tcl-name behavior behavior-name
—
Exit policy view
quit
—
Apply
the QoS
policy
To an
interface
Applying the QoS policy to an interface
—
To online
users
Applying the QoS policy to online users
—
Configuring traffic policing in non policy-based approach
NOTE:
Support of the H3C WX series access controllers for this feature may vary by AC model. For more
information, see Compatibility Matrices.
With a user profile configured, you can perform traffic policing based on users. When
any user of the user profile logs in, the authentication server automatically applies the
CAR configured for the user profile to the user. When the user logs off, the system
automatically removes the configuration without manual intervention.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English