H3C WX Series

57
PQ configuration procedure
You can configure PQ by applying a PQ list to an interface. For an interface, the latest
applied PQ list overwrites the previous one.
Follow these steps to configure PQ:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Configure a PQ
list
qos pql pql-index protocol ip
[ queue-key key-value ] queue
{ bottom | middle | normal | top }
or
qos pql pql-index
inbound-interface interface-type
interface-number queue { bottom
| middle | normal | top }
or
qos pql pql-index
local-precedence
local-precedence-value queue
{ bottom | middle | normal | top }
Required
Use a command as needed.
Specify the
default queue for
the PQ list
qos pql pql-index default-queue
{ bottom | middle | normal | top }
Optional
This command specifies the
queue to which unmatched
packets are assigned to.
By default, unmatched packets
are assigned to the normal
queue.
Set the queue
size
qos pql pql-index queue { bottom |
middle | normal | top }
queue-length queue-length
Optional
Enter interface
view
interface interface-type
interface-number
—
Apply the PQ list
to the interface
qos pq pql pql-index
Required
FIFO applies by default
Display PQ list
configuration
information
display qos pq interface
[ interface-type interface-number ]
Optional
Available in any view