H3C WX Series

61
Configuration procedure
Follow these steps to configure CQ:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Configure a CQ list
qos cql cql-index protocol
protocol-name queue-key
key-value queue
queue-number
or
qos cql cql-index
inbound-interface
interface-type
interface-number queue
queue-number
or
qos cql cql-index
local-precedence
local-precedence-value
queue queue-number
Optional
Use a command as needed.
Specify the default queue
qos cql cql-index
default-queue
queue-number
Optional
This command specifies the
queue to which unmatched
packets are assigned to.
By default, the unmatched
packets are assigned to
queue 1.
Set the length of a queue
qos cql cql-index queue
queue-number
queue-length queue-length
Optional
Configure the bytes sent
from a queue during a
cycle of round robin
queue scheduling
qos cql cql-index queue
queue-number serving
byte-count
Optional
Enter interface view
interface interface-type
interface-number
—
Apply the CQ list to the
interface
qos cq cql cql-index
Required
FIFO applies by default.
Display interface CQ list
configuration information
display qos cq interface
[ interface-type
interface-number ]
Optional
Available in any view