Page 122
Alarms
103 IncorrectBottleLoadedinPosition4
• Incorrect bottle detected in position 4.
• Analyzer cannot perform bottle test operation.
104 NotEnoughFluidinBottle1
• Not enough fluid in bottle 1 to complete operation.
• Check bottle 1 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
105 NotEnoughFluidinBottle2
• Not enough fluid in bottle 2 to complete operation.
• Check bottle 2 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
106 NotEnoughFluidinBottle3
• Not enough fluid in bottle 3 to complete operation.
• Check bottle 3 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
107 NotEnoughFluidinBottle4
• Not enough fluid in bottle 4 to complete operation.
• Check bottle 4 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
118 UnableToChangeLanguageSettings Analyzer cannot change language settings.
119 UnableToReadLanguageSettings Analyzer cannot read language settings
120 UnableToChangeEthernetSettings Analyzer cannot change Ethernet settings.
121 UnableToReadEthernetSettings Analyzer cannot read Ethernet settings.
122 UnableToPrintSystemSettings Analyzer cannot print system settings.
125 UnableToStartLampTest Analyzer cannot start lamp test.
126 UnableToStopLampTest Analyzer cannot stop lamp test.
127 UvLampLifeExceeded
• Lamp hours of usage have been exceeded or UV Detect™
output has dropped below acceptable limit.
• Lamp has been set to a status of marginal.
• Replace lamp.
129 UnableToReadInformationFromBottle Analyzer cannot read information from bottle.
130 UnableToWriteInformationToBottle Analyzer cannot write information to bottle.
131 UnableToStart4to20mAOutputs Analyzer cannot start 4-20 mA output test.
132 UnableToStartPumpTest Analyzer cannot start pump test.
133 UnableToStopPumpTest Analyzer cannot stop pump test.
134 UnableToCalibratePump Analyzer cannot calibrate pump.
135 UnableToExportDataLog Analyzer cannot export data log.
136 UnableToExportAuditTrail Analyzer cannot export audit trail.
137 UnableToAddUser Analyzer cannot add a user.
138 UnableToEditUser Analyzer cannot edit a user.
139 UnableToDeleteUser Analyzer cannot edit a user.
141 UnableToAcknowledgeAlarms Analyzer cannot acknowledge alarm.
142 UnableToDeleteAlarms Analyzer cannot delete alarms.
143 UnableToStartSelfClean Analyzer cannot start self clean.
144 UnableToStopSelfClean Analyzer cannot stop self clean.
145 UnableToStartOnlineManualSample Analyzer cannot start online manual sample.
146 UnableToStopOnlineManualSample Analyzer cannot stop online manual sample.
147 UnableToRestoreFactoryDefaults Analyzer cannot restore factory defaults.
148 UnableToStartVoltageTest Analyzer cannot start voltage test.
Table 16 Warning alarm messages
Code Message Alarm condition
To Next Page
Loading...
