50/64 CMp | Installation
Bosch Rexroth AB, RE 15409 Version 08.2022,
7.3.1.7 Tank
7.3.1.8 Drive unit ambient temperature sensor
Fig. 53: Temperrature sensor SLSP 14
The interface used for the temperature sensor/switch is G 1/2" (see Fig. 53).
If another interface is used please contact your local Bosch Rexroth representative.
Note! The sensor must be conneted with the control system of the drive to maintain
the functionality.
Fig. 54: Example, mounting positions of ambient temperature sensor SLSP 15
Recommended position of the ambient temperature sensor is on the ange on
the frame of the drive unit (DUe), see g Fig. 54. The steel plate ange should
be used. If there is only a rubber variant where sensor should be placed, see if a
replacement between the anges is possible. Prefered positions of the sensor are
on the back or left/right side of the frame.
Do not place the sensor closed to a wall! Wrong ambient temperature could be
meassured.
DD00078702
DD00078702
To Next Page
Loading...