– 41 –
11. Unlatch three sump latches. All three
latches can be reached from the front of
the dishwasher in most installations. If the
dishwasher does not have the legs extended;
the dishwasher may have to be removed from
its installed position.
12. Push the sump from the bottom into the tub.
13. Grasp the sump from inside. Using care, tilt
and lift to bring the sump into the tub. Bring
the drain pump up and in rst. This allows
access to disconnect the wiring in the next
step.
NOTE: It is important to route the wire
harnesses in the same locations to prevent
future damage to the harness.
14. Disconnect the circulation pump wiring, drain
pump wiring and ood switch wiring.
To Next Page
Loading...
Need help?
General
