Haier LT32F6 - Tuning Menu Options - Scanning; Channel Scan Initiation

p.13
| HD Ready LCD TV | User Manual
Use Up or Down Cursor 8.
31
to select
Scan to start scan or select Skip Scan
to skip this step. Then press Right
Cursor
31
or OK Button
12
to continue
or press Left Cursor
31
to go back.
See g. 18, 19.
NOTE: If you skip this step, the channel
scan could be performed in Menu.
System searching may take few 9.
minutes to complete.
See g. 20.
A message will be displayed when 10.
the search is complete. Press the OK
Button
12
to exit the initial setup wizard.
The TV will display the rst channel
found.
See g. 21.
Vol
31
12
g. 18
Channel Scan
Scan
Skip Scan
0%
Initial Setup
First, please connect antenna.
Start channel scan now?
If you skip this step, the channel scan
could be performaed in Menu.
ExitBack Select Next
EXIT
g. 19
Channel Scan
4%
Initial Setup
The channel scan may take a while to
complete.
Status: Scanning..
Analogue Channels: 0
ExitBack Select Next
EXIT
g. 20
CompletedInitial Setup
Congratulations !!
Completed Initial Setup.
Please press [OK] to exit the wizard.
Back
g. 21
TUNING MENU OPTIONS