Hammond XK-3 User Manual

Setting the Parameters
71
OD/VIB (OverDrive / VIBrato)
In this mode, you can do the setting relating to each Effect for Overdrive and
Vibrato/Chorus.
To come to this mode:
1. Touch the [MENU/EXIT] button to display the MENU, select PAGE C by the [PAGE]
button, and then touch the [1] OD/VIB button.
2. Or, hold down the [TUBE AMP] button for a while.
OVERDRIVE
1. DRIVE
This is for adjusting the Overdrive Value.
The more the value gets, the more distortion you can get.
This is linked with the [TUBE OVERDRIVE] knob on the
front panel.
2. BLEND
This is for setting the Tone Range for Distortion.
The setting range is 0 to 63. The more the value increases, the
easier gets the treble to distort. The less the value gets, on the
contrary, the easier gets the bass to be distorted. It is in the
same ratio at 32.
NOTE: This parameter functions when the Preamp - Type (4) is
at “Dual 1” or “Dual 2”.
3. EXPRESSION
This is for varying the Overdrive value by operating the
Expression.
EX-OD:
If you operate the Expression, not only the volume but
also the distortion will be changed.
OD-EX:
The Expression affects only the volume and not the
distortion value.
4. PREAMP - TYPE
This is for choosing the Tube Amp Circuit.
Dual 1:
This is an amp with two circuits for low and high
frequency band. The separation is loose.
Dual 2:
This is an amp with two circuits for low and high
frequency band. The separation is tight.
Singl:
This is an amp with a single circuit, same as the
ordinary overdrive effects. It treats all ranges by 1
circuit.
5. PHASE
This parameter reverses the phases of the two tube amp
circuits.
ON: Reverse
OFF: Normal
Usually, it should be “ON”.
NOTE: This Parameter functions when the Pre-amp - Type (4) is
at “Dual 1” or “Dual 2”.
6. CROSSOVER
Here you can set the Crossover Frequency of two bands of the
Tube-Amp circuits.
The setting range is 125 - 800 Hz.
NOTE: This parameter functions when the Preamp - Type (4) is
at “Dual 1” or “Dual 2”.
VIBRATO/CHORUS
7. VIBRATO - RATE
This is for setting the Speed of the Vibrato/Chorus Effect.
The setting range is 6.10 - 7.25 Hz.
NOTE: The parameters in these modes are Preset Parameters
and are recorded to each Combination Preset.
1 2 3 4 5
7
6

Hammond XK-3 Specifications

General

Brand	Hammond
Model	XK-3
Category	Electronic Keyboard
Language	English