Setting the Parameters
75
SYSTEM
In this mode, you can set the SYSTEM PARAMETERS of this keyboard and the
display information.
To come to this mode:
Touch the [MENU/EXIT] button to display the MENU, select PAGE E by the [PAGE]
button, and then touch the [2] SYSTEM button.
1. NOISE GATE - RETURN
Switches the action of the Noise-Gate of the Effect Loop and the Return terminal.
THRESHOLD 1,
THRESHOLD 2:
The voice output is switched ON/OFF according to the volume input to the
Return jack.
THRESHOLD 2 switches ON/OFF at lower volume than THRESHOLD 1.
OPEN:
The voice output is always ON.
2. VERSION - MAIN PROGRAM
3. VERSION - TONE INFORMATION
4. VERSION - KEY SCAN PROGRAM
These are the versions of each software built in this keyboard.
These are only for displaying, and not the items to set.
NOISE GATE
The Noise Gate is a device to eliminate noises while
you are not playing. If the input tone signal goes
down below a certain level (= “Threshold Level”),
this automatically “close”s the gate and gets silent,
to cut the noise.
However, this sometimes could be a problem. This
happens when a sound signal with a slow attack or
release is put in, for example, when such an Effector
as Slow Gear or Delay is connected to the Effect
Loop of this keyboard. The sound may suddenly
come out or be cut off all of a sudden.
In such a case, you must always “open” the gate to
pass all signals.
2 3 4
1
To Next Page
Loading...
Need help?
General
