Contents
System
Installation
Using
the product
Assembly &
Disassembly
BIOS
Appendix
Touch Screen
System
Introduction
MSR
Kitchen Printer Bell
Winclon (Backup)
Winclon (Restore)
POS Driver & Utility
Do not apply a severe impact to the touch screen or press the screen with a sharp object such as a ball-point pen.
This may damage the touch screen.
■Touch Point Setup
Touch Screen
When you use the touch screen for the first time or the pointer does not precisely match your touch, calibrate the touch screen
in the ‘eGalaxTouch’. The calibration process for the touch screen may differ depending on the operating system and may not be available in
some operating systems. The following descriptions assume the Windows POSReady2009 operating system.
① Click start→All Programs→eGalaxTouch→Configure Utility
② Click the 'Tools' tab and ‘4Points Calibration’
③ When the Calibration window appears, touch the point represented by the “+”.
④ The “+” is displayed from the bottom left to the top left of the screen sequentially.
⑤ The Touch screen input points are calibrated.
To Next Page
Loading...
