Setup/Installation
20
Pressing the LOG key again will stop the Interval
logging session. The “LOG STOPPED“ message will
be displayed for a few seconds.
If a sensor failure occurs during interval logging, the
message “OUT OF FREE SPACE” will alternate with
logging information
Manual Logging
Select Manual in the SETUP menu. To initiate a
Manual log, press the LOG key while the instrument
is in measurement. The “PLEASE WAIT” screen will
be displayed briey followed by a screen indicating
the measurement has been saved and then the log
record number.
Following the saved and recorded number, the
amount of free space will be displayed. The “LOG”
tag will be displayed on all 3 screens.
Stability Logging
Select Stability and choose measurement stability
criteria in the SETUP menu. Only Stability Medium
is available in Basic mode. To initiate the Stability
log, press the LOG key while the instrument is in
measurement.
The “PLEASE WAIT” screen will be displayed briey
followed by a screen showing the stability tag,
“LOG” tag and a “WAITING” message. The log can be
stopped while the “WAITING” message is displayed
by pressing LOG again.
Logging
Function
To Next Page
Loading...
Need help?
General
